You are likely to experience your car door freezing and refusing to open on a cold morning during a Canadian winter. This often occurs when moisture seeping into the rubber seal (weatherstrip) freezes and sticks to the door frame, or when water inside the lock cylinder freezes, preventing the key from turning. Since forcing the door open can break the handle or tear the seal, the proper procedure is to let the ice melt before attempting to open it.
When the door won't open — melt the ice first.
1. Press inward with your palm Before pulling the handle, place your palm against the door and press firmly inward. Often, the door opens as the ice crystals attached to the rubber seal break. This is sufficient for light frost.
2. Spraying de-icing spray (Deicer) — This is the fastest and most reliable method. Spray it into the gap between the door and the car body, rubber seals, handles, and keyholes, wait 1 to 2 minutes, and then try opening it slowly. The small de-icer specifically designed for locks is convenient to carry in a coat pocket.
3. Spraying a mixture of rubbing alcohol and water — If you do not have de-icing spray, mix rubbing alcohol (isopropyl alcohol) and water in a 2:1 ratio, put it in a spray bottle, and spray. Alcohol has a very low freezing point, so it melts the ice. Wait 30 seconds to 1 minute, then press to open it. However, since alcohol can dry out rubber, use this only as an emergency measure.
4. lukewarm water — Slowly pour lukewarm water (about 37°C) at body temperature along the gap in the door to melt the ice. Do not pour directly into the glass. Boiling water is strictly prohibited.Cold glass can suddenly shatter, and melted water can refreeze, making the situation worse.
5. Hair dryer If power is available, slowly shining a medium heat along the gap in the door is also a good method. Work from the bottom hinge upwards, and do not hold it in one spot for too long at a time.
When the lock is frozen
If the key does not turn, do not force it. This could cause the key to break or damage small parts inside the lock. Spray de-icing spray or an alcohol mixture directly into the keyhole, wait a moment, then insert the key and try turning it while gently shaking it. Graphite powder is good for general lubrication but does not melt ice, so it is ineffective when the lock is frozen.
Prevent it from freezing again — Pre-winter prevention
If you apply a thin layer of silicone spray or silicone gel to the rubber seals before winter arrives, water will not seep in, preventing them from freezing. Applying it just once or twice during the middle of winter is effective. It is also helpful to get into the habit of wiping the rubber seals with a dry cloth after washing the car or after rain or snow. If the door is left open, apply silicone spray to the seal. The next cold morning will be much easier.
Source: Reader's Digest — How to Open a Frozen Car Door on a Cold Morning (https://www.rd.com/article/how-to-open-frozen-car-door/), The Daily Automotive — How to Thaw Frozen Car Doors(https://thedailyautomotive.com/how-to-unthaw-frozen-car-doors/) |